The Marshall Islands-flagged bulk carrier Sigma Pearl ran aground near Kakinada, Andhra Pradesh, India, on October 28, 2026, after reportedly losing propulsion during Cyclone Arnab.
The vessel was reportedly traveling from Visakhapatnam to Singapore after discharging a cargo of sulfur when it experienced a suspected engine failure. Strong winds and rough seas subsequently pushed the vessel toward the coast near Antarvedi.
On October 29, the Indian Coast Guard launched a rescue operation involving a helicopter and patrol vessel to assist six crew members reportedly aboard the stranded ship.
Initial reports indicated that the crew were safe, although their evacuation had not been confirmed.
Authorities were monitoring the situation and assessing recovery options.
No confirmed information was available regarding hull damage, pollution or plans to refloat the vessel.
Over the past week, 20 to 26 October, one incident of piracy or armed robbery against ships in Asia.
The CAT 4 incident occurred onboard a tug boat and barge while underway in the eastbound lane of the Traffic Separation Scheme (TSS) in the Singapore Strait, approximately 4.3 nautical miles off Pulau Nongsa, Indonesia, on 17 October 2026. Six unarmed perpetrators were involved in the incident, during which scrap metals were stolen. The crew members were not injured.
Area of concern
With the incident reported in the Singapore Strait, a total of 25 incidents has been reported in the Straits of Malacca and Singapore (SOMS) since January 2026.
Ships are advised to intensify vigilance and maintain a sharp look-out while transiting areas of concern and report all incidents immediately to law enforcement agencies. The Centre also urges the littoral States to increase patrols and enforcement in their respective waters, respond promptly to incidents, strengthen coordination and promote information sharing on incidents and the criminal groups involved to arrest the perpetrators.
Not all hazards are obvious at first glance. Conditions such as limited lighting and compromised footing can increase risk and make hazards more difficult to recognise, in the latest instalment of its Good Catch series.
Taking a few moments to assess the work environment before starting a task can help prevent injuries, falls overboard and other incidents that may have lasting consequences for seafarers. Identifying potential hazards early and addressing them before work begins can make a critical difference in keeping everyone on board safe.
Against this backdrop, the case in which a deckhand on an inland towing vessel fell overboard while working in a barge fleeting area.
A crew member suffered second-degree chemical burns after a concentrated fuel biocide was incorrectly used to clean fuel oil strainers, according to a safety flash.
The chemical penetrated the worker’s clothing, and the exposure continued when the contaminated coveralls were worn again the following day. The incident highlights how inappropriate chemical selection, inadequate protective equipment and delayed decontamination can turn routine maintenance into a serious injury.
What happened
During maintenance work involving fuel oil strainers, a crew member used a concentrated fuel biocide as a soaking and rinsing agent. However, the substance was intended exclusively as a fuel additive and was not suitable for cleaning equipment.
While carrying out the task, the worker wore standard cotton coveralls rather than the chemical-resistant protective clothing required for handling the substance. The chemical mixture soaked through the fabric, exposing the worker’s skin to its corrosive effects.
Unaware of the chemical’s hazardous properties, the crew member did not immediately wash the affected skin. The situation was aggravated when the same contaminated coveralls were worn again the following day, extending the period of contact with the chemical.